Welcome toDongguan Keyang Automation Equipment Co., Ltd.Official website!

Electric sliding table
your current location : Home >> News >> Industry News

Addr:Dongguan Mayor Anzhen Wusha Ring East Road Chen House brand building.

Tel:0769-89368511 / 33388293

Mobile:13925552470(Wechat Code)

Fax:0769-89032105

Q  Q:2850923180

Email:wdp@keyangauto.com

website:en.keyangauto.com


How to store and maintain the linear module guide rail?

2020-03-31

As a mechanical transmission component, the linear module is very fast during operation, so does the mechanical engineer know how to store and maintain the linear module guide rail?

linear module

Use of linear modules:

1. The ambient temperature should not exceed 80℃, and the instantaneous temperature should not exceed 100℃

2. When removing the slider from the linear guide or replacing the slider, please use the false rail to assist in the installation, and do not remove the slider from the guide unless necessary.

3. Use in special environment, for example: frequent vibration, high powder layer, high and low temperature, please contact the senior engineer.


Storage:

When storing the linear guide, please be sure to coat it with anti-rust oil and seal it in the specified envelope, and place it horizontally, and avoid high temperature and high humidity environment.


Take:

1. The slider and linear guide may fall down due to their own weight after tilting, please be careful.

2. Knock or break the linear guide, even if the appearance does not appear to be damaged, it may cause engineering losses, please be careful.

3. Do not disassemble the slider by yourself, as foreign objects may enter the linear guide or adversely affect the assembly accuracy.

4. When handling the heavy linear guide, please use more than 2 people or use a handling tool to avoid possible injury to personnel or damage to the workpiece.

5. Pay attention to prevent foreign matter and foreign matter, resulting in slider failure, damage and loss of function.


lubricating:

1. Please wipe the anti-rust oil first and then seal it with lubricating oil.

2. Do not mix lubricating oils of different properties.

3. When using lubricating oil, it will be different due to different installation methods, please contact the senior engineer first.

4. After filling the lubricant, firstly push the slider back and forth for at least 3 slider length strokes, repeat this action more than 2 times, and confirm whether the surface of the linear guide is evenly coated with oil film.


(Part of the material on this website comes from the Internet. If the information displayed on this website infringes your copyright or other legitimate rights and interests, please notify us in time, and this website will be deleted in time.)




Label

Last viewed: