The storage of mechanical products has always been a problem faced by people, especially with the development of mechanization and automation, there are usually more mechanical products that everyone sees, so today I will introduce a mechanical product to you. storage method. Linear modules are a type of mechanical products. Usually, even if you buy linear modules, you only buy one or two, so there is not much care and attention for its storage; but the direct manufacturers of those linear modules or It is a customer factory, which may need to store a large number of linear modules for some reasons. How should they store linear mods? What will happen if it is not stored properly?

Mechanical products are afraid of rust, oxidation, exposure, degaussing, etc. Therefore, linear modules as mechanical products should also pay attention to these problems. If linear module manufacturers and customer factories store a large number of linear modules. First of all, it is necessary to ensure that the storage environment temperature is neither too high nor too low, and it is placed at room temperature; the storage environment should not be too humid to avoid rust and oxidation.

If the linear module is not stored properly, such as in a high temperature environment, it will lead to the demagnetization of the motor of the linear module specification or the reduction of the rigidity of the screw. If the linear module is in a high temperature environment for a long time, the Some metal objects will chemically react with oxygen, carbon dioxide, etc. in the air, resulting in damage to the linear module or loss of performance.

Of course, if the linear module is stored in a low temperature environment, it is prone to rust problems, because the air will contain a lot of moisture when the temperature is low. After the linear module is rusted, its precision, operation speed or service life will be greatly affected.

In simple terms, linear modules are stored at room temperature and the environment is relatively dry. This storage environment is good; especially for the direct manufacturer of linear modules or customer factories, when faced with seasonal reasons or It is because the market environment is not stable that the shutdown is caused. The linear modules and other production equipment must be strictly stored to avoid failures when they are used again.